A Ironworks company - serving Winchester, NV

Pedestrian Gate in Winchester, NV

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate
Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Pedestrian Gate in Winchester, NV

A pedestrian gate is the walk-through gate beside your driveway gate: the one your mail carrier uses, the one your grandchildren run through to the front door, and the one that has to latch every single time without a shove. In Winchester, we install and repair swing and sliding pedestrian gates in steel, aluminum, and ornamental iron, matched to your existing fence line and to the driveway gate it stands next to. Most pedestrian gate jobs are finished in a single visit, and every one is backed by our written 90-Day Done Right Promise. Call (866) 984-8340 for a free estimate.

We’re gate specialists, not a general handyman service. That matters on pedestrian gates because the failure points are specific: hinges that sag, posts that shift, self-closing hardware that gives up, and magnetic locks that stop talking to the keypad. Our technicians have up to 13 years of experience, and they work the installation side and the automation side of the same job. If your entry needs a full system instead, start with Gate Installation in Winchester and we’ll scope it from there.

When You Need a Pedestrian Gate

Pedestrian gates don’t usually fail all at once. They wear in ways you notice slowly and then can’t ignore. These are the situations Winchester homeowners call us about most:

  • The gate drags on the ground or won’t latch without a lift. In Winchester’s dry summer heat, wood and steel both move, and a post that was plumb in March can pull out of line by August. A gate that has to be lifted to close is a gate that will eventually be left open.
  • The self-closing hinge has stopped closing. Springs in self-closing hinges lose tension after years of daily use. You’ll notice the gate resting half-open after the mail carrier leaves. That’s a hinge problem, not a gate problem, and it’s a quick fix.
  • You want the walkway secured without opening the driveway every time. Many homeowners in the older neighborhoods around Winchester want the pool area or side yard locked off but still want foot traffic to the front door to work naturally. A separate pedestrian gate does that without cycling a heavy driveway gate all day.
  • The keypad or magnetic lock has quit. Access control on a pedestrian gate usually means a keypad, a magnetic lock, or a request-to-exit button. When one piece fails, the whole entry stops working. We service LiftMaster and FAAC access hardware and can diagnose which component actually failed instead of replacing the whole assembly.
  • A new pool or fence project needs a code-compliant walk gate. Pool barriers and property-line fences both call for a self-closing, self-latching pedestrian gate. We build those to spec so the gate does its job the first time.
  • The driveway gate works but the walk gate was never installed. Plenty of homes have a working automated driveway gate and an open gap beside it. Adding a matching pedestrian gate closes that gap and looks like it was always there.

Our Pedestrian Gate Process

Here’s what a pedestrian gate job with us looks like, from the first call to the final walk-through.

  1. You call and talk to a person. A live person answers the phone 24 hours a day, 7 days a week. No voicemail tree, no callback queue. We’ll ask what the gate is doing, how old it is, and whether it’s manual or automated, then set a time that works for you.
  2. We come out and measure the actual opening. Gate width, post condition, grade, and clearance all get checked in person. If the existing post is failing, we say so before we quote. That’s where a lot of pedestrian gate jobs go wrong: someone hangs a new gate on a post that was already moving.
  3. You get an upfront price before any work starts. We settle the number with you first, in plain language, with no surprises on the bill. If a repair makes more sense than a replacement, we’ll tell you that too. Our Free Second Opinion on Any Written Estimate is there if you’ve already got a quote in hand from someone else.
  4. We build or repair the gate and set the hardware. Hinges, latches, self-closers, and any access control get installed and adjusted on site. Most jobs are completed in a single visit, because our technicians are trained and equipped on the major automation brands. That includes LiftMaster, FAAC, Elite, and Mighty Mule, so the correct part goes on the first time.
  5. We test it the way you’ll use it. Open, close, latch, repeat. We check that the gate swings freely, that the self-closer actually closes, and that the lock releases cleanly from the keypad. Then we walk you through it before we leave.
  6. The 90-Day Done Right Promise covers it in writing. If something isn’t right in the first 90 days, we come back and make it right. No paperwork, no arguing. That’s the Keystone Standard, and it applies to every pedestrian gate job we do.

Pedestrian Gate Pricing in Winchester

Most pedestrian gate work in Winchester runs between $250 and $1,400 depending on whether we’re repairing, replacing, or building new. A hinge and latch adjustment is at the low end. A new ornamental iron walk gate with posts and self-closing hardware sits at the high end. Here’s how the line items break down:

Job Typical Range
Hinge, latch, or self-closer repair $150 – $350
Post reset or replacement $250 – $600
New manual pedestrian gate, steel or aluminum $450 – $1,100
Ornamental iron walk gate, fabricated to fit $700 – $1,400
Keypad or magnetic lock replacement $300 – $700

A few things move the number. Gate width and height, material (aluminum costs less than fabricated iron), whether the post has to be dug and set, and whether the gate ties into an existing access control system. Automation adds cost, but on a pedestrian gate it’s usually a self-closer and a lock rather than a full operator, so the jump is smaller than people expect.

We quote before we touch anything, and we don’t add charges after the fact. Current standing offers: $50 Off Any Repair Over $250, and a permanent 5% Senior and Veteran discount. An $89 Seasonal Tune-Up is worth asking about if your pedestrian gate and driveway gate are both due for adjustment. Call (866) 984-8340 for a free estimate.

FAQs – Pedestrian Gate

How much does pedestrian gate repair cost in Winchester?

Pedestrian gate repair in Winchester typically costs $150 – $350 for hinge, latch, or self-closer work, and $250 – $600 if the post needs to be reset or replaced. Access control repairs like a failed keypad or magnetic lock run $300 – $700. Call (866) 984-8340 for an exact quote, and estimates are free.

Can you install a pedestrian gate that matches my existing driveway gate?

Yes. We build walk gates to match the style, height, and finish of an existing driveway gate so the two read as one entry. Bring us a photo or let us look at it in person, and we’ll match the pickets, rails, and paint or powder coat. We handle the full scope of Gate Installation, from hinges and welds to keypads and automation. Call (866) 984-8340 to set up a free estimate.

Can a pedestrian gate be automated?

Yes, though most Winchester homeowners choose a self-closing hinge and a lock rather than a powered operator, since a walk gate doesn’t need to open from a car. When a powered pedestrian gate does make sense, we service the automation brands we’re trained on, including LiftMaster and FAAC. If you’re weighing options, call (866) 984-8340 and we’ll tell you honestly which setup fits your property.

Can you come out the same day?

Often, yes. Because most pedestrian gate jobs are completed in a single visit and a live person answers the phone around the clock, we can frequently schedule same-day or next-day. Call (866) 984-8340 and we’ll tell you what’s open.

Related Services

Pedestrian gates rarely live alone on a property. These are the pages Winchester homeowners most often need next:

Whatever gate or hardware your entry needs, we handle it and stand behind it in writing. Background-checked, uniformed technicians guide every job, and the 400th job gets the same care as the first.

Get a Free Pedestrian Gate Estimate in Winchester

If your walk gate drags, won’t latch, or was never there in the first place, the fix is usually simpler than you’d expect. Call Ironworks Gate Co. Winchester at (866) 984-8340 for a free estimate. A live person answers 24 hours a day, 7 days a week. We’ll look at the gate, quote you upfront, and get it done right, backed in writing.

Written by the team at Ironworks Gate Co. Winchester, serving Winchester.

Need Gate Repair help in Winchester? Licensed & insured · 60-minute response · free estimates
Call (866) 984-8340
Local Service Coverage

Request a Free Estimate in Winchester

Tell us what you need - Ironworks Gate Co. Winchester responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch