Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateDoorKing Keypad & Intercom Repair: The Winchester Owner’s Guide
DoorKing keypad and intercom repair in Winchester typically runs $185 to $420 installed, depending on whether we’re replacing a keypad, an intercom station, or both, and most jobs are finished in a single visit. We service the full DoorKing line, so the part gets matched to your unit on the first trip rather than the second. Owners usually find out something failed the same way: the gate stops answering the code that worked for years, or the call button rings inside the house but no one can hear the visitor on the other end.
Which DoorKing Models This Applies To
DoorKing builds two families you’ll run into on Winchester driveways: the 1500 series residential access controls and the 1800 series, plus the 1812 and 1833 slide and swing operators that carry factory keypad and intercom modules. Each uses different faceplate cutouts and wiring harnesses, which is where most DIY mismatches happen. Pull the faceplate and read the model and revision sticker on the back of the board before you order anything. A 1500 keypad will not drop into a 1833 housing without the right adapter plate.
On the OEM question, DoorKing factory parts fit correctly and carry the right connector, but quality aftermarket equivalents exist for common failure points like keypad membranes and intercom speakers. We’ll tell you which one makes sense for your unit and your budget. Ironworks Gate Co. Winchester is an independent service provider, not affiliated with DoorKing, so our recommendation is based on what fits and lasts, not on a brand agreement. We don’t claim to stock DoorKing parts; we source the correct part for your model and bring it to the job. We also service LiftMaster, Mighty Mule, and Ghost Controls systems if your setup is mixed.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your DoorKing Keypad & Intercom Repair Is Failing
- Codes stop working but the gate opens from a remote. Usually a worn keypad membrane or a failed control board input, not the operator itself. The remote side of the board still works, which tells us the gate motor is fine.
- The call button rings inside but audio is dead or crackling. The intercom speaker or microphone has failed, often from years of desert heat cycling the cone material. You’ll hear the ring because that circuit is separate.
- Keys feel mushy or need a hard press. The membrane is wearing through. In Winchester, fine dust works into the keypad face and accelerates this, so a unit near a gravel drive fails faster than one on pavement.
- Backlight flickers or the display fades. A failing power supply or a corroded connection at the terminal strip. Loose low-voltage connections cause most of the flickering we see.
- Gate opens on its own. A stuck keypad key sending a constant signal. This one needs attention now, since an unattended gate cycling open is a real security and safety problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s how the numbers break down for Winchester homeowners:
| Job | Installed Range |
|---|---|
| Keypad replacement (membrane or full unit) | $185 – $280 |
| Intercom station replacement | $240 – $360 |
| Keypad and intercom together | $380 – $520 |
| Control board input repair (no new part) | $150 – $240 |
What drives the range: whether we’re swapping a component or the whole station, the model, and whether the wiring or terminal strip needs repair while we’re in there. The price is quoted and agreed before any work starts, so there’s no surprise on the bill. Every job is covered by our written 90-Day Done Right Promise. Labor and the part are stated separately so you can see exactly what you’re paying for. We’re happy to give a free second opinion on any written estimate you already have.
DIY or Call Us?
You can safely check a few things yourself: confirm the breaker or low-voltage supply to the unit is on, look for water or insect intrusion inside the housing, and note whether the gate opens from a remote but not the keypad. That last detail alone points us straight to the keypad side. What we’d steer you away from is rewiring the intercom or control board connections. These run on low voltage, but a miswired terminal can backfeed the operator and trip a safety edge mid-cycle, and some DoorKing modules tie into the gate’s safety circuit. The bigger risk is buying the wrong part twice. We’d rather you call and let us match it right the first time. A live person answers at (866) 984-8340, day or night.
FAQs
Expect 7 to 12 years from a keypad and 10 to 15 from an intercom station, with the shorter end of that range on units facing direct afternoon sun. The Las Vegas Valley’s heat and dust wear keypad membranes faster than a mild climate would, so a west-facing unit can fail years earlier than the same model in shade.
Yes, often. A dead key or crackling audio can sometimes be fixed by replacing just the membrane or the speaker rather than the whole unit, which saves money. We’ll tell you honestly which path makes sense once we’ve seen the board. Call (866) 984-8340 for a free estimate and we’ll give you the straight answer.
Most keypad and intercom swaps take 45 minutes to 2 hours, and most jobs are done in a single visit. Complex control board work or wiring repair adds time. We’ll tell you the realistic window when we quote it, and we’ll be there when we say.
We match the replacement to your exact model and revision number and source the correct part before the visit. That’s why we ask you to read the sticker on the back of the board first, so you’re not paying for a return trip. Our technicians have up to 13 years of experience and work on nine gate-automation brands, so the fit gets checked against the real unit. Estimates are free, and the price is settled before we start.
If your DoorKing keypad is dropping codes or your intercom has gone quiet, don’t wait on it. Call Ironworks Gate Co. Winchester at (866) 984-8340 for a free estimate, and we’ll match the part, agree the price upfront, and back the work with our written 90-Day Done Right Promise. We also have $50 off any repair over $250, an $89 seasonal tune-up, and a standing 5% senior and veteran discount.
Written by the team at Ironworks Gate Co. Winchester, serving Winchester and nearby areas.